|
Car Detailing In Atlanta Resource
Preferred Tools of the Trade - part 3
Heat Sources
In-line Heaters
You dont need to warm up or preheat cleaning solution. Produces vibrant heat immediately.
You must use two power cords due to the high amperage draw. You may need to plug into two separate shop circuits. This can be inconvenient if one power cord goes in one direction and the other goes across the shop to an independent circuit.
In-tank Heaters
Turn on the machine to preheat the cleaning solution.
Once the machine is warm and if it has a stainless steel tank it will work fine throughout the day. Use the preheat setting between details.
In-tank heaters draw less power and require only one cord to operate.
Using Chemicals
Extractors use fewer chemicals than manual cleaning.
Using a spray bottle, spot spray grease or heavy traffic areas for best results. Avoid putting a more aggressive cleaner through the extractor pump.
Clean your pump with a 3:1 solution of white vinegar and water. Run this through the machine once a month. This will keep your machine in prime condition and it will perform expertly.
Highly Efficient
Your extractor machine easily replaces cleaning by hand with a bucket and brush. You are much more efficient using this method of cleaning.
Extractor Cleaning Instructions
To begin, vacuum the interior and remove all debris. No need to get the small, lint type dirt, as the extractor removes all of the smaller, lint type particles as well as the really deep dirt.
Spray the cleaning solution throughout the area to be cleaned. Use a pre-spotter with heavy soiled stains and allow this solution to penetrate well.
Go for a small, short bristled brush to help dislodge the toughest stains and ground in dirt. Use the solution/vac to remove the dirt.
You will find that drying time is quicker using this method compared to hand vacuuming.
To make your time more efficient, use the various styles of tools available. They are made of both stainless steel and plastic.
The standard upholstery wand is used more than any other is. Use it to clean some 95% of the work on your average customers car interior.
Use the crevice tool to clean in between seats and areas that cannot be reached with the standard upholstery tool.
The floor wand is a detailers preferred tool. Use it for vans and in your showroom. Some shops take their show on the road using this tool and clean carpets in restaurants, offices, and other venues.
You will no longer have to abide by any specifically set amount of hours, and your lunches are your own. Networking: it is beneficial for you to gather and maintain business contacts. Dont look for ways to cut costs at the expense of your quality service and performance. Believe it or not, you also have to register for a special tax number so that you can charge the taxes to your customers. You want your customers back quickly. Getting the Loan Be entirely prepared before you apply for the loan. |
